Fusion™ Mineral Paint is famous for its built-in topcoat.
The 100% acrylic resin acts as the “glue”, so to speak, and results in the best adhesion, and long-term durability against wear and tear. It is a waterproof, non-porous surface which is why you don’t need a topcoat.
Sometimes you may want a glossy sheen and added color vibrancy, or you may want the peace of mind of an extra bit of protection over high-traffic areas such as kitchen cabinets or tabletops. This is where our Tough Coat™ comes into play!
Normally other products on the market use lesser acrylic resins which will yellow and embrittle over time, not binding as well, therefore, leaving a less durable finish. We have done extensive testing to ensure that we are offering you the best of the best. The following image shows how Fusion™’s Tough Coat™ up to 3 years of UV exposure in comparison to a competitor brand. As you can see, the Fusion™ Tough Coat™ maintains its clear transparency while the competitor brand yellowed.
Tough Coat™ uses only 100% acrylic resin and is perfect as a topcoat sealer for those high traffic surfaces such as tabletops, seating, and doors and dries to a glossy finish. Fusion™ Tough Coat™ differs from our competition by using pure non-yellowing acrylic.
The keys to applying Tough Coat™ to your projects are: Use sparingly and work quickly as it dries fast! When applying, do not pass over the same area more than 2-3 times. We recommend using a fine microfiber applicator like our applicator pads for a smooth consistent finish.
If applying to a recently painted surface, allow the surface to dry for 12 hours before applying. For maximum durability, apply two coats waiting 2-4 hours between applications. In humid areas, longer drying times may be required.
Tip: When applied to darker colors, imperfections may be more noticeable. It is best to sand down any imperfections between coats to acquire that flawless finish.
Be sure to gently mix your Tough Coat™ by gently rolling it around prior to using it as the matting agent and other ingredients may settle to the bottom. Do not shake vigorously as this will cause air bubbles in your piece that are difficult to remove once applied. If bubbles begin to occur on your piece, simply remove excess Tough Coat™ from your brush and gently brush out the bubbles. Tough Coat™ will begin to dry as you’re using it. In order to avoid brush strokes, try not to spend too much time on one spot and do not back brush (usually no longer than 30 seconds).